General Section
47
Below are abbreviations that may appear on the
Identification, Lift Capacity and Attachment Plate
and their meanings.
Mast Abbreviations
STD -
Standard Mast
(single inner member, low free lift)
FF -
Full Free Lift Mast
(single inner member with high free lift
duplex cylinder)
FFT -
Triple Lift Mast (two inner members) with
either low or full free lift characteristics.
QUAD Quadruple (Quad) Mast(with three inner
members)
NOTE: When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
Attachment Abbreviations
(includes Special Forks)
SC-
Special Carriage-increased width,
height or outreach
SSS - Shaft-type Side shift Carriage
HSS - Hook-type Side shift Carriage (ITA)
CW - Counterweight
SF -
Special Forks
SWS -
Swing Shift, Side shift
RAM - Ram or Boom
DBCBH -
Double Cube Block Handler
HFP -
Hydraulic Fork Positioner
CR -
Crane Arm or Crane Boom
TH -
Tire Handler
CTH -
Container Handler
LPP - Load Push-Pull Device
CC - Carton Clamp
RC - Roll Clamp
LS - Load Stabilizer
PWH -
Pulp Wood Handler
SS-ST - Side shift-Side Tilt Carriage
To Next Page
Loading...
