Operation Section
90
Emergency Lowering Device
WARNING
If the carriage fails to descend when the lift lever
is pushed forward, it can be lowers using the
emergency lowering valve in the control box. Do
not stay beneath or near the carriage when
using the emergency lowering valve, otherwise,
you may get severely injured.
Observe the following procedure when using the
emergency lowering valve.
1. Stop the engine and open the door of the control
box on the right side of the operator.
2. Turn the nut and adjusting screw of the
emergency lowering valve by 2 turns
counterclockwise. The carriage will descend
slowly.
3. When the carriage is on the ground, tighten the
adjusting screw and nut to prevent further
settlement by the valve.
4. Close the control box door.
Parking Brake Lever
NOTICE
Do not engage the parking brake while the lift truck
is moving unless an emergency exists. The use of
the parking brake as a service foot brake in regular
operation will cause severe damage to the parking
brake system.
Mechanical Parking Brake (If Installed)
The parking brake lever is located at the left side of
the steering wheel.
Electronic Parking Brake (If Installed)
How to Operate
How to Release the Parking Brake
1. Sit on the operator's seat and check that the
lever is in neutral.
2. With the brake pedal pressed, start the ignition.
3. Check that the instrument panel's parking brake
lamp is on.
4. Press the parking brake switch, which is located
on the right side of the seat. Then, check that
the parking brake lamp turns off and the buzzer
sounds three times.
5. Put the direction control lever in forward or
reverse.
6. Release the brake pedal and operate the
vehicle.
To Next Page
Loading...
