OP001013
2-53
Operating Controls
SEAT BELT
Seat Belt Locking and Unlocking
Insert belt end (1, Figure 106) into buckle (2). Pull belt to check
that belt end is locked into buckle.
Adjust belt length so that it comfortably tight against operator's
pelvic region (hipbone).
Press button (3, Figure 107) in center of buckle (2) and pull out
belt (1) to unlock.
WARNING
Seat belt is for operator's safety and should always be
worn. Before driving machine, adjust seat to desired
position for maximum comfort and machine control, then
fasten seat belt. Seat belts must be worn across pelvic
region and adjusted snugly to lessen chance and severity
of injury in event of an accident. Never fasten a seat belt
across abdomen.
Under no circumstances should operator be standing in
cabin when operating wheel loader.
Do not adjust seat position while vehicle is moving because
a loss of control may result. Stop machine, apply parking
brake, and then adjust seat.
Always, check condition of seat belt and belt bracket before
fastening it. Do not use it with twists in it. Replace belt or
bracket if damaged or worn.
Figure 106
HAOB140L
Figure 107
HAOB150L
To Next Page
