OP001015
4-1
Inspection, Maintenance and Adjustment
OP001015
4Inspection, Maintenance
and Adjustment
BASIC PREVENTIVE
MAINTENANCE
For the machine to function satisfactorily and at lowest possible
cost, a thorough maintenance program is required. This section
of the manual describes the maintenance work which the
operator can carry out. If certain operations require trained
workshop personnel and special equipment, this will be
indicated.
The intervals recommended between checks, oil changes and
lubrication apply provided that the machine is used under
normal environmental and operating conditions. See
“Lubrication and Service Chart” on page 4-17
Arrival and Delivery Inspection
Before the machine leaves the factory, it is tested and adjusted.
The dealer must also, if the warranty is to apply, carry out
"Arrival and Delivery Inspections" according to applicable form,
which must be signed.
Delivery Instructions
When handing the machine over, the dealer must give the buyer
"Delivery Instructions" according to applicable form, which must
be signed, if the warranty is to apply.
Figure 1
To Next Page
