Need help?Do you have a question about the Doosan F30i Series and is the answer not in the manual?
General| Manufacturer | Doosan |
|---|---|
| Power Type | Electric |
| Load Capacity | 3, 000 kg |
| Load Center | 500 mm |
| Mast Type Options | Duplex, Triplex |
| Lift Speed (loaded) | 480 mm/s |
Emergency stop button pressed or axis limit switch tripped.
Alarm from the main spindle drive unit.
Circuit protector in electric cabinet is tripped.
Excessive electric current detected in hydraulic pump motor.
Cycle start performed without restoring reference point manually (X, Y, Z axis).
Air pressure switch tripped due to air pressure falling below specified value.
Excessive electric current detected in coolant or lubricant pump motor.
Door in the main OP side is open.
Coolant chiller unit that cools coolant has a problem.
Release key of splash guard's door-close check safety switch is opened.
Axis (X,Y,Z,B) tripped Axis Interlock, disabling Handle/Jog mode.
Operator side/splash guard door not opened before Spindle Tool Unclamp.
Tool change (M06) or tool call (T__) command instructed with K7.6 (disable ATC) set.
ATC Door Close/Open command incomplete within 20 sec, or door not closed in APC.
Error found when detecting initial position of ATC changer.
Left/right position sensor signal did not match instruction signal after 5 seconds.
To Next Page