Need help?Do you have a question about the Doosan HM 1250 and is the answer not in the manual?
General| Brand | Doosan |
|---|---|
| Model | HM 1250 |
| Category | Industrial Equipment |
| Language | English |
Steps to dismantle the tool unclamp cylinder, including preparations and component removal.
Procedures to take apart the spindle cartridge for repair, including cleaning and tube removal.
Detailed steps for installing the spindle cartridge, including bearing and gear placement.
Instructions for reassembling the tool unclamp cylinder, focusing on labyrinth and lock-nut installation.
Procedures for disassembling the piston shaft, including marking positions and loosening bolts.
Steps to install the piston shaft, O-rings, dog, and cylinder cap, ensuring correct fitment.
Manual restoration of the ATC servo magazine reference point if sub changer and tool pot are misaligned.
Steps to align the ATC and spindle, including spindle orientation and centering fixture setup.
Sequence chart outlining the steps for the M06 tool changing operation, including checks and alarms.
Step-by-step guide to dismantle the ball screw on the X axis, including parts list and diagrams.
Detailed instructions for installing the ball screw on the X axis, covering bearing and bracket fitting.
Procedures for taking apart the ball screw on the Y axis, with diagrams and part numbers.
Steps for installing the ball screw on the Y axis, including bearing and motor bracket assembly.
Guide to dismantle the ball screw on the Z axis, detailing component removal and motor bracket separation.
Instructions for installing the ball screw on the Z axis, covering bearing fitting and lock nut tightening.
Procedures for measuring and correcting the straightness of the Z axis in X-Y and Y-Z planes.
To Next Page
