Need help?Do you have a question about the Doosan NHP Series and is the answer not in the manual?
General| Brand | Doosan |
|---|---|
| Model | NHP Series |
| Category | Industrial Equipment |
| Language | English |
Prepare the centering fixture with Center Bar, Fixture for Changer Arm, and Fixture for Spindle.
Install the centering fixture between tool pot and sub changer, move sub changer to pot position.
Push center bar into centering fixture to check changer arm alignment with tool pot.
Operate servo drive to enable jog run and adjust pot position using arrow keys.
Press SET key after centering, then switch to origin mode and hold SET key for 10 seconds.
Use center bar to check alignment and adjust sub changer horizontally using hydraulic cylinder screw.
Install centering fixture, move sub changer to waiting position, adjust tool carrier pot.
Use center bar and side stopper for fine adjustment of tool carrier pot left/right position.
Use center bar and vertical adjustment bolts to correct vertical mismatch of tool carrier pot.
Use gap gauge and stopper to adjust distance between tool carrier pot and sub changer.
To Next Page