Doosan HM 5000 User Manual

16 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Machine Tools

ATC Troubleshooting

(HM 5000/6300/8000)

Table of Contents

(1) If the changer arm is stuck while trying to pull out a tool from the spindle (in the state of Tool Unclamp)3
In most cases, this happens when the changer arm is stuck in the spindle while trying to pull out a tool after Utool unclamping is performedU, causing to trigger the " 2062 M06 Command Over Time” alarm.3
(2) If the changer arm is stuck in the spindle after changing a tool (in the state of Tool Clamp)3
In most cases, this happens when the changer arm gripper is stuck in a tool after Uthe changer arm changed the tool and performed the tool clampingU, causing to trigger the " 2062 M06 Command Overtime” alarm.3
(3) If the changer arm has stopped operation irrelevantly to the spindle3
This happens if the machine is emergency stopped or there occurs a power failure while performing the tool changing.3
▶ ATC Recovery3

Questions and Answers:

Need help?

Do you have a question about the Doosan HM 5000 and is the answer not in the manual?

Doosan HM 5000 Specifications

General

Brand	Doosan
Model	HM 5000
Category	Industrial Equipment
Language	English

Related product manuals

Doosan F30i Series

Doosan NHP Series