Doosan HM 5000 - Document Management; Revision History Log

16 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

14

HM 5000/6300/8000 HM4digitATCE26

Revision History

ATC Troubleshooting HM 5000/6300/8000

Version Year/Month Revision history Created by

01 2012. 06 Created a draft (HM4digitATCE26) Jung, Sam Young

02

03

04

05

06

07

08

09

10

Table of Contents

(1) If the changer arm is stuck while trying to pull out a tool from the spindle (in the state of Tool Unclamp)3
In most cases, this happens when the changer arm is stuck in the spindle while trying to pull out a tool after Utool unclamping is performedU, causing to trigger the " 2062 M06 Command Over Time” alarm.3
(2) If the changer arm is stuck in the spindle after changing a tool (in the state of Tool Clamp)3
In most cases, this happens when the changer arm gripper is stuck in a tool after Uthe changer arm changed the tool and performed the tool clampingU, causing to trigger the " 2062 M06 Command Overtime” alarm.3
(3) If the changer arm has stopped operation irrelevantly to the spindle3
This happens if the machine is emergency stopped or there occurs a power failure while performing the tool changing.3
▶ ATC Recovery3

Related product manuals

Preview: Doosan NHM Series

Doosan NHM Series

Doosan F30i Series

Doosan NHP Series