Need help?Do you have a question about the Doosan NHM Series and is the answer not in the manual?
General| Brand | Doosan |
|---|---|
| Model | NHM Series |
| Category | Industrial Equipment |
| Language | English |
Install fixtures to align the sub changer and tool pot.
Verify the magazine's home position using centering fixtures.
Use JOG mode to adjust the magazine's tool pot position.
Center the magazine chain pot using the centering fixture.
Set the reference position for the magazine after centering.
Adjust sub changer and chain pot alignment using centering bar.
Align sub changer and tool carrier pot positions.
Adjust left/right and vertical positions of the tool carrier pot.
Measure and adjust the gap between tool carrier pot and sub changer.
Check spindle orientation and adjust parameters if needed.
Prepare centering fixtures for ATC and magazine alignment.
To Next Page
