Maintenance
- 98 -
CAUTION:
Crankshaft revolution is done by hands without using a starting motor.
Turn it to the direction of engine rotation, but do not use the installing bolts at the turn.
The cylinder no. and the order of intake and exhaust can be determined from the crank shaft
pulley.
Adjust valve clearance with a feeler
gauge and tighten the fixing nuts to
specified torque.
3.3.34. Timing trigger
Install the coupling and drive gear on
the bearing housing shaft.
Assemble the ignition timing sensor
bracket, prevent cover and sensor.
Model Intake valve Exhaust valve
GL08K
0.3 mm 0.3 mm
EA8M3007
Valve clearance adjust
Valve clearance adjust
Torque 4.4 ±0.45 kg
•
m
To Next Page
Loading...
