Doosan GL08K - Page 109

Maintenance - 103 -
 Placed in the ignition timing mark on the
crankshaft pulley.
3.3.47. ECM, ICM and harness
 Assemble the engine control
module(ECM) and Ignition control
module(ICM) on the cylinder block.
 Connect the harness and various
sensors.
3.3.48. Oil level gauge
 Apply sealant (Locktite #262) to the
bottom side of the guide tube.
 Then assemble the guide tube and oil
level gauge on the oil pan.
Timing pointer
ED4OM059
(ECM)
J2-B
J2-A
J1-C
J1-B
J1-A
EI4OM009
Engine control module
EQM3005I