Make sure the unit is well ventilated and away from direct sunlight. To avoid damage to internal
circuitry, as well as the external finish, keep the unit away from sources of direct heat (heater vents,
stoves, radiators, etc.).
Avoid using flammable aerosols, etc., near the server. They may damage the surface and may ignite.
Do not use denatured alcohol, paint thinner, or similar chemicals to clean the server. They will
damage the finish.
Modification of this equipment is dangerous and can result in the functions of the unit being impaired.
Never attempt to modify the equipment in any way.
In order to ensure optimum performance of your server, select the setup location carefully and make
sure the equipment is used properly. Avoid setting up the server in the following locations:
1. In a humid or dusty environment.
2. In a room with poor ventilation.
3. On a surface which is not level.
4. Inside a moving vehicle where it will be subject to vibration.
5. In an extremely hot or cold environment.
Removable Drives Warning
Removal of the hot swappable hard drives allows access to pins and traces supplying power to the
hard drive backplane. These are considered energy hazards.
REMOVAL OF HARD DRIVES MAY ONLY BE PERFORMED BY TRAINED SERVICE
PERSONNEL. CONTACT DOREMI FOR TRAINING PROGRAMS. With regards to the energy
hazard warning and removable drives, the equipment may only be used in a restricted access
location (not accessible to the general public).
CAUTION
• Battery is located on the motherboard.
• Danger of explosion if battery is incorrectly replaced.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to the manufacturer’s instructions.
D2K.DP.000255.DRM Page 5 Version 1.6
Doremi Cinema LLC
To Next Page
Loading...
