DORMA •
ES 200 Easy
ES 200
ES 200 20
Door remains open in the program
Detector is emitting a continuous Remove connector of radar motion
switch settings: AUTOMATIC,
signal
detector. If fault is cured by this,
PERMANT OPENING, and
replace radar movement detector
PARTIAL OPENING
Basic module indicates error •.[ •.
The learning cycle has not been
Perform learning cycle
(obstruction during
performed (the door weight is sti II
commissioning)
undetermined)
The blocking sensor is too sensiti-
Adjust blocking sensor to door set
ve for the door set (e.g. small,
with the help of the force
high and heavy door leaves)
limitation (OPEN, CLOSE) and the
delay time via the PDA
Door does not open when the External detector
Remove activator connector and
program switch is set to:
bridge the input. If the fault is
AUTOMATIC, EXIT ONLY,
cured by this, check supply
PERMANT OPEN, and
voltage (27 V) of the basic module
PARTIAL OPEN
and the detectors. If it is okay
check and replace detectors if
required.
Internal detector
Remove activator connector. If the
door opens, check supply voltage
(27 V) of the basic module and
the detectors. If it is okay check
whether self-monitoring detector
that works according to the fail-
safe principle is connected.
Unpleasant operating noise
Screw presses against track roller
Replace or trim screw
Control unit displays error code "H"
The basic module has been Restore original settings.
connected to a 2D door system Perform a learning cycle.
and is expecting a FST mod ute.
ES 200
C048:
ES 200
C048:
The rubber bell don't opens the
Check the rubber belt,
door replace if required.
DAC
300 OAC
300
The solenoid don't held the
Check the solenoid and the
rubber belt. tension of the rubber belt,
replace if required.
1il~ 6. Troubleshooting
'{I
0
~~
~
~
To Previous Page
Loading...
