Need help?Do you have a question about the Dorma SST FLEX ES 200 and is the answer not in the manual?
General| Product Type | Automatic Sliding Door Operator |
|---|---|
| Power Supply | 230 V AC, 50/60 Hz |
| Operating Temperature | -15°C to +50°C |
| Control System | Microprocessor-based control |
| Protection Class | IP 20 |
| Closing Force | Adjustable |
| Application | Commercial and public buildings |
| Type | Sliding |
| Max Door Weight (Single Panel) | 120 kg |
| Max Door Leaf Weight | 120 kg |
| Max Door Width (Bi-Parting) | 2400 mm (1200 mm per panel) |
| Opening Speed | Adjustable up to 700 mm/s |
| Closing Speed | Adjustable up to 500 mm/s |
| Hold-Open Time | 0 - 60 s (adjustable) |
| Power Consumption | 100 W |
| Safety Standards | EN 16005 |
| Safety Features | Obstacle detection |
Covers electrical safety, child safety, and general handling precautions.
Details voltage, fuse, noise levels, and adherence to regulations.
Focuses on risk evaluation and dangers at closing edges.
Provides instructions for proper product and packaging disposal.
Covers work area security, water protection, fixing, and qualified personnel.
Details requirements for earth conductor, sensors, and panel linking.
Outlines annual checks, personnel training, and operator handover.
Covers maintenance steps and replacement schedules for wear parts.
Confirms compliance with EU directives and harmonized standards for the product.
Specifies when the SST-FLEX ADDITIONAL KIT is needed for specific door widths.
Details reinforcement for long girders and lists all mounting components.
Illustrates the steps for mounting the aluminum girder and required fasteners.
Details kit usage for specific door widths and shows the overall panel layout.
Covers the installation of floor pivot sets and top side panel bearings.
Details the installation of latch bolts, plates, and overall panel fixing.
Explains control unit wiring and references relevant commissioning documents.
Specifies kit requirements based on door width and shows the panel layout.
Details the process of installing the floor-integrated guide rail.
Illustrates attaching components and making initial adjustments.
Covers aligning the sliding panel and detailed tilt adjustment.
Explains using specific adjustment screws for fine-tuning panel tilt.
Illustrates the overall steps for adjusting the door system's operation.
Shows panel layout and reiterates kit requirements for system configuration.
Details precise latch adjustment and setting force limits for safety.
To Next Page
