To Next PageTo Next Page
Need help?Do you have a question about the Dorma CD 80 and is the answer not in the manual?
General| Brand | Dorma |
|---|---|
| Model | CD 80 |
| Category | Door Opening System |
| Language | English |
Details door leaf width, weight, and fixing positions for standard doors.
Lists adjustable parameters like opening/closing time and hold-open time.
Outlines standard and optional functions and programs available.
Lists accessories compatible with the drive unit.
Provides specifications like closing force, dimensions, weight, and power supply.
General guidance on electrical work, maintenance safety, and routine inspection.
Details electrical supply requirements and safety precautions.
Step-by-step guide for fixing the operator, mounting plate, and slide channel.
Procedures for mounting the drive unit onto the mounting pins.
Details on closing valves, securing the arm, and fitting the slide channel.
Explains adjustments for door closer and automatic operator modes.
Adjusting the closing speed from 7° to 0° for proper lock engagement.
Lists prerequisites for commissioning the operator.
Procedure to set the operator to factory default values.
Steps to initiate the door's learning cycle for programming the opening angle.
How to set the extended hold-open time for specific scenarios.
Process for adjusting the door's full opening angle.
Instructions for activating parameterisation mode using T1/T2 buttons.
Details adjustable parameters like opening time, hold-open time, and wall blanking.
Check functions of operating and control elements.
Explains how LED 2 indicates faults and refers to troubleshooting.
Identifies common faults, possible causes, and remedies.
Explains LED 1 (green) and LED 2 (red) fault indication codes.
Overview of operator control elements like main and program switches.
Details functions of the AUTOMATIC, OFF, and PERMANENT OPEN modes.
Information on using the extended hold-open function.
Instructions for activating and using the Push&Go function.
Explanation of the Power Assist mode and its effect on door force.
Settings for delayed opening and backcheck function.
How to use the emergency pushbutton to deactivate functions.
Diagram showing wiring for the CD 80 operator with sensor.
Details connections for radar and safety sensors.
Wiring diagrams for program switch and emergency pushbutton.
Wiring for electric strikes and motor power supply.
