Dorma TS93 GSR/EMF User Manual

Tool List:
Tape Measure #10-32 Tap & Holder No. 21 (.159”) & 1/8” Drill Bits and Drill Hacksaw
Center Punch & Hammer 1/2” Box Wrench #2 Cross-Point Screw Driver
3/16” Slotted Driver 10” Adjustable Wrench 2.5mm, 3mm & 5mm Hex Wrench (supplied)
INSTRUCTIONS
INS NO: 08281031 PAGE: 1 of 11 REV: 09/11
TS93 GSR/EMF PT
LEFT HAND INACTIVE
RIGHT HAND ACTIVE
RIGHT HAND INACTIVE
ATTENTION!!!
Before you begin, determine installation type (RIGHT HAND ACTIVE OR INACTIVE).
Door coordinator suitable for door from 59” to 98” in width. Inactive door width in the case of unequal doors
is a 23” minimum. Also, you will need the tools listed below.
LEFT HAND ACTIVE

Dorma TS93 GSR/EMF Specifications

General

Application	Single and double leaf doors
Closing Force EN	3-6
Max. Door Width	1400 mm
Fire Rated	Yes
Barrier-free	Yes
Backcheck	Yes
Adjustable Closing Speed	Yes
Material	Aluminum
Voltage	24 V DC
Product Type	GSR/EMF
Power Size	3-6
Hold-open	Yes
Finish	Silver
Sliding Channel	Yes

Summary

GSR/EMF - Hold Open Functionality

Understanding GSR/EMF Hold Open

Explains how the electric hold open device enables doors to be held open independently or together.

Setting Release Force

Guidance on adjusting release force to suit door width and size, with a caution for high settings.

Installing Covers and Trim

End Cap Trim and Covers Installation

Instructions for clipping end cap trims and breaking out recesses for track cover installation.

Center Cover and Center Caps Installation

Procedure for determining center cover length, cutting, clipping, and fitting jointing elements.

Final Installation Procedures

Closer Covers Installation

Steps for sliding end covers over closer body end caps and securing covers with locking screws.

Carry Bar Installation

Requirement for a carry bar (MK-398) for doors 3'-6" and wider to ensure proper closure.

Final Installation and Test

Checking connections, testing door positions, and activating EMF system for electromagnets release.