Dorma ED400 User Manual

1
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211
DL3128-010
Lake Bluff, IL 60044 Fax: 877-423-7999 10/1/2007
E-mail: automatics@dorma-usa.com Subject to change without notice
ED400 In Floor
Controller Manual
DORMA
ED400 Concealed “In Floor”
AUTOMATIC SWING DOOR
Controller Installer’s Manual
Distributed by:

Dorma ED400 Specifications

General

Brand	Dorma
Model	ED400
Category	Door Opening System
Language	English

Summary

INSTALLATION

Operator installation

Instructions for mounting the operator unit.

Controller installation

Steps to install the controller, including wiring the motor and encoder.

Motor

Connects the motor cable to the controller and checks wiring for correct operation.

Encoder

Sensors

Program Switch

Emergency: Fire and Break-Out

AC Power

Door or arm installation

SET-UP

Quick Start

Step-by-step guide for initial opener adjustment and learning.

Basic Adjustments

OPERATION

AC power

Restore factory defaults

Opener Type

Set-up without temporary stop

Cycle testing

Presence

Obstacle

Alarm

Type menu

Mount menu

Open Speed menu

Back-Check menu

Back-Stop menu

Close Delay menu

Close Speed menu

Latch-Check menu

Opening Obstacle submenu

Closing Obstacle submenu

Deceleration submenu

Reset / restore submenu

TROUBLESHOOTING

Electrical

Information on fuse replacement and potential electrical issues.

Fuse replacement

Procedure for replacing AC line input and motor fuses.

Plugging AC to Motor Connector

Warning against plugging AC power into the Motor connector.

Learn State

Event codes

Bad value

Particular situations

Power off: ease of motion

Display is dark

Opener won't learn

Opener won't open, manual opening is OK

Opener keeps door open at Back-Stop

Opener pushes door hard against the Latch-Stop

Opener keeps door open against the operator's hard-stop

Opener stuck assisting

Opening door bumps against the hard-stop

Angle displayed doesn't match door angle

SPECIFICATIONS

Control inputs

Power

Safety

Safety features like passive closer operation and alarm inputs.

APPENDIX

WIRING

Detailed wiring instructions for encoder, motor, and AC power.

Encoder / Cam Switch wiring

Motor wiring

AC Power wiring

Set-up: