To Next PageTo Next Page
Need help?Do you have a question about the Dorma ED700 and is the answer not in the manual?
General| Control System | Microprocessor control |
|---|---|
| Adjustable Closing Speed | Yes |
| Power Supply | 230 V AC |
| Operation Modes | Automatic, Manual |
| Safety Features | Obstacle detection |
| Backcheck | Adjustable |
| Latching Action | Yes |
| Temperature Range | +50°C |
Ensuring safe operation and compliance with industry standards like BHMA/ANSI 156.19.
List of tools required for installation, including screwdrivers, wrenches, and drills.
Procedure to drive the operator to the fully-open hardstop using the controller.
Requirements and steps before starting the initial door operator setup procedure.
Steps to initiate the operator's learning cycle and basic configuration.
Wiring instructions for connecting electric strikes or magnetic locks via relays.
Instructions on using the program switch for different operational modes.
Guidelines for periodic checks, cleaning, and servicing of the door operator.
Troubleshooting common door operation issues like failure to open or close.
