Dorma ED700 - Controller & Switch Installation

Connect Motor and Encoder Harnesses
OR
#1 Endcap
SYNC
TXD
GND
RXD
PGM
ENC
Breakout
2-1/8”
#2 Header Bottom
Recommended Locations for Mode Switch.
(Phillips screwdriver required).
#6-32 x ½”
SYNC
TXD
GND
RXD
Breakout
PGM
ENC
Place Mode Switch in opening and fasten.
ED700
Low Energy
Automatic Swing Door
DORMA
8
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211
Lake Bluff, IL 60044 Fax: 877-423-7999
DL3038-010 Rev. B 6/08
E-mail: automatics@dorma-usa.com Subject to change without notice
ENC
Controller installation.
Fasten using supplied mounting pads to
the back of the controller and the header.
SYNC
TXD
GND
R
XD
PGM
Breakout
INSTALL THE CONTROLLER and ON OFF HOLD SWITCH (PROGRAM)
1
2
2
1
DO NOT PLUG MOTOR HARNESS INTO POWER, IT WILL DAMAGE MOTOR!
PGM
ENC
Breakout
SYNC
GND
TXD
RXD
3/4”
1 1/2”
Drill #36 (Ø.107)
(2plcs)
Drill Ø1” hole for clearace.