Installation of Surface Applied - Pull Application.
Note:For installation with 0” reveals.
Incoming 120VAC
(opposite pivot)
Unit Width
(= Door width + 3”)
1”
4”
1-1/2”
4”
1-
1/4
”
23-1/2
”
Mount the Pull Arm (For 0” Reveals)
PGM
ENC
Breakout
SYNC
TXD
GND
RXD
MICROPROCESSOR CONTROL
115 VAC 60 Hz 2A
DORMA AUTOMATICS
Phone: 877-367-6211
Motor: 4A slow blow
Line: 2A fast acting
THIS OPERATOR CONTROLLER MUST BE
ADJUSTED TO MEET ANSI STANDARDS
BY DORMA TRAINED PERSONNEL
5-1/2”
5”
ED700
Low Energy
Automatic Swing Door
DORMA
16
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211
Lake Bluff, IL 60044 Fax: 877-423-7999 DL3038-010 Rev. B 6/08
E-mail: automatics@dorma-usa.com
Subject to change without notice
To Next Page
Loading...
