Dorma ED700 - Connecting the Controller

7
Motor
Controller
Brown
Black
Green
Mode Switch
Hold open
ON
OFF
Connect Operator Internal Wiring to Control
Jumper
Required
ENCODER
Black
Use supplied
green connector
Sensor connections
see page - 10
Green
Red
Left Side
Right Side
Use supplied
green connector
Connecting the Controller
Breakout
PGM
ENC
SYNC
TXD
GND
RXD
To RXD
To TXD
To GND
Optional: use when
synchronizing two operators
MICROPROCESSOR CONTROL
115 VAC 60 Hz 2A
DORMA AUTOMATICS
Phone: 877-367-6211
Motor: 4A slow blow
Line: 2A fast acting
THIS OPERATOR CONTROLLER MUST BE
ADJUSTED TO MEET ANSI STANDARDS
POWER
115 Vac
White
Black
Green
Green
GROUND ATTACHED TO HEADER
NOTE: For LH or LHR, Red and Black leads must switch
Jumper
Required
Brown
Black
Green
Mode Switch Function
Brown
Black
Green
ED700
Low Energy
Automatic Swing Door
DORMA
9
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211
Lake Bluff, IL 60044 Fax: 877-423-7999
DL3038-010 Rev. B 6/08
E-mail: automatics@dorma-usa.com Subject to change without notice