DORM
ED400 In Floor
Controller Manual
22
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211 DL3128-010
Lake Bluff, IL 60044 Fax: 877-423-7999 10/1/2007
E-mail: automatics@dorma-usa.com Subject to change without notice
SPECIFICATIONS
Main features
• Overhead Concealed Mount or surface mount (push or pull)
• Center pivot or offset hinges
• Complete: doesn't require a power-boost module, nor a brake box
• Hand is field reversible
Control inputs
• Seven sensor inputs (individual LEDs indicate status):
o Trigger (radar, motion detector, push plate, access control, RF receiver…)
o Header (jamb) mounted presence sensor
o Door mounted, approach side presence sensoroDoor mounted, swing side presence sensor
o Safety beam presence sensor
o Fire (Smoke alarm)
o Breakout switch
• Input for Program switch (Off/Auto/Hold Open)
• All inputs, except for the Fire and Breakout inputs, are active low, compatible with:
o dry contact
o open collector
o TTL
o any signal up to 24 Vdc
• Fire and Breakout inputs are active open.
Control outputs
• Electric strike lock, open collector 100 mA max, 24 Vdc max. not protected. (requires additional relay,
not included; requires external supply, not included, for electric locks other than 24 Vdc)
• Data (for dual zone sensors, such as BEA DK-12)
o Door closed: open circuit (0 Vdc)
o Door closing: 500 Hz square wave
o Door opening or open: 12 Vdc unregulated, 100 mA source max
Control inputs/outputs
• Synch cable for side-by-side openers (part number DS2715-010)
o RXD TXD.
Power
• Input: 115 Vac, 2 A Max
• Output: 24 Vdc, 0.8 A, unregulated, short circuit protected, for sensors and accessories
Safety
• Operates as a passive door closer in case of power failure or controller failure
• Smoke alarm and breakout switch input
Misc
• Operating air temperature -40 to 50 °C
• Small size: 8" wide x 4 " tall x 2.5" deep
• Microprocessor controlled, FLASH re-programmable, replaceable
• Two controllers may be synchronized for side-by-side doors
• Closed loop control
To Next Page
