Dorma ED400 - OPERATION; Restore factory defaults; Set-up without temporary stop; Cycle testing

DORM
A
ED400 In Floor
Controller Manual
26
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211 DL3128-010
Lake Bluff, IL 60044 Fax: 877-423-7999 10/1/2007
E-mail: automatics@dorma-usa.com Subject to change without notice
OPERATION
Restore factory defaults
To reset the unit to the factory defaults, do the following:
o Turn the "Selector" knob to the "Misc Sel" position.
o Turn the "Dial" knob until "rSt" is shown in the display.
o Turn the "Selector" knob to the "Misc Adj" position. The display will show "nO".
Turn the "Dial" knob right. The display will show "yES" for just a split second, and thecontroller will restart.
Set-up without temporary stop
If for some reason you don't want stop the door at Electrical Back-Stopduring set-up, use this alternate procedure:
• Manually open the door until it hits a mechanical stop (such as a wall or the operator'sinternal
Hard-Stop). Measure that opening angle exactly.
• Turn on the controller
• Indicate the type of door opener and the door mount.
• Turn the "Selector" knob to the "Back-Stop" position. Use the Dial knob to change the Back-Stop
angle to the angle you just measured.
• Turn the "Selector" knob to the "Learn" position.
• Set the Program Switch in the "Auto" position.
• The door will start opening slowly and hit the hard-stop.
• As the door closes slowly to Latch-Stop, turn the "Selector" knob to the "Back-Stop" position. Use
the Dial knob to change the Back-Stop angle to the desired Electrical Back-Stop Angle (such as 90°).
• Get out of the way!
• The door will slam open to 45°, then close.
• The display will show "CyC", meaningthat the opener needs a cycle learn.
• The door will cycle open and closed at normal speed once.
Cycle testing
To cycle test the operator, do the following:
• Apply AC power to the controller.
• Set the Program Switch in the "Off" position.
• Turn the "Selector" knob to the "Back-Stop" position. The display shows the programmed
Back-Stop angle in degrees.
• Turn the "Dial" knob to adjust the programmed Back-Stop angle to the actual Back-Stop angle of
the door.
• Turn the "Selector" knob to the "Learn" position. The display shows the Learn State. If it doesn't say
"ALL" (meaning it needs a complete learn), turn the"Dial" knob counter-clockwise until it does.
• Set the Program Switch in the "Auto" position. The opener will start a learn:
o The door will open slowly to Back-Stop.
o The door will close slowly to Latch-Stop.
o The door may slam partially open, then close.
o The door will start cycling open and close, non stop.Note that the opener has limited obstacle
detection while learning: do not stop the door!
• Turn the "Selector" knob to the "Mon Sel" position.
• Turn the "Dial" knob until that "CyC" (for Number of Cycles) is shown in the display.
• Turn the "Selector" knob to the " Monitor" position. The display will show the number of cycles. If
there are morethan 999 cycles, use the "Dial" knob to scroll the display.