Step 1:
At the bottom of the lock front housing there
is an outlet for the 2-prong device.
Step 2:
Inset the prongs from the back-up device in
the outlet.
Step 3:
Hold down the red button on the back-up
device. The front left green light will appear.
You must continue to apply pressure to the red
button or power will be cut.
IMPORTANT
If the front right light is illuminated yellow,
you must change the batteries of the device
(4x AAA) as there may not be enough
power to open the lock.
If there is no light, this means that the
batteries on the back up device are drained.
Please change them.
Step 4:
After a few seconds you should notice the
lock’s power-up sequence: the motor will turn
to the locked position and the green LED on
the lock will flash 3 times.
Step 5:
While keeping the back-up device connected
to the lock, present a keycard to the lock to
unlock the door.
Step: 6
Green light on front lock housing will light up
when successfully unlocked. Remove the
back-up device from the lock. Open the
door and change lock batteries.
Follow these steps for each Saffire LX lock
with battery failure.
CAUTION
The lock may remain in the unlocked state
until the batteries are changed or until the
back up device is re-applied, in the following
situations:
• If the back up device is removed
while unlocked
• If you stop applying pressure on the
red button of the back-up device
while the green light on the lock is
still flashing
To Next Page
Loading...
Need help?
General
