EasyManua.ls Logo

Doro 6521 - Charge the Phone

Doro 6521
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
4. Insert the battery by sliding it into the battery compartment with the
contacts facing downwards to the right. Replace the battery cover.
IMPORTANT!
This device accepts micro SIM or 3FF SIM card. Use of incompatible SIM
cards may damage the card or the device, and may corrupt data stored
on the card.
IMPORTANT!
Use only compatible memory cards for use with this device. Compatible
card type: microSD, microSDHC.
Incompatible cards may damage the card itself, the device and corrupt
data stored on the card. Depending on the market some phones may
have a pre-installed memory card.
Charge the phone
CAUTION
Only use batteries, chargers and accessories that have been approved for
use with this particular model. Connecting other accessories may be
dangerous and may invalidate the phone's type approval and warranty.
When the battery is running low,
is displayed and a warning signal is
heard.
1. Connect the mains adapter to a wall socket and to the charging socket
y. The battery charge indicator is animated while charging. It takes
approximately 3 hours to fully charge the battery. When the charger is
connected to the phone,
is displayed briefly, and when it is
disconnected.
2. When charging is completed,
is displayed on the screen.
If the phone is turned off when the charger is connected to the phone
only the battery charge indicator will be shown on the display.
Note! To save power the LCD backlight goes off after a while. Press any
button to illuminate the display. Full battery capacity will not be reached
until the battery has been charged 3–4 times. Batteries degrade over time,
which means that call time and standby time will normally decrease with
regular use.
2

Table of Contents

Related product manuals