Dors 1050 - Delivery Set and Appearance; Delivery Set Contents; Device Appearance Overview

7
6
WARNING! UNPLUGING THE DEVICE FROM THE POWER OUTLET, HOLD THE PLUG,
NOT POWER CORD TO AVOID ANY DAMAGE OF THE CORD.
WARNING! TO AVOID ANY POWER CORD DAMAGE AND A SHORT CIRCUIT, MOVE THE
DEVICE ONLY AFTER THE POWER CORD PLUG HAS BEEN DISCONNECTED FROM THE
POWER NETWORK.
IT IS PROHIBITED TO INSTALL THE DEVICE WITH ITS UV-LAMP BEING VISIBLE FOR
THE OPERATOR.
ATTENTION! IF THE DEVICE HAS BEEN UNDER COLD CONDITIONS FOR A LONG TIME,
IT SHALL BE KEPT UNDER ROOM TEMPERATURE FOR NOT LESS THAN TWO HOURS
BEFORE ITS SWITCHING ON.
ATTENTION! TO PROVIDE A SUCCESSFUL OPERATION OF THE DEVICE FOR A LONG
TIME WITHOUT AN INTERFERENCE OF A TECHNICIAN, OBSERVE THE FOLLOWING
RULES:
1. THE DEVICE SHALL BE INSTALLED ON AN EVEN HORIZONTALSURFACE.
2. WHEN INSTALLING THE DEVICE, AVOID ITS EXPOSURE TO DIRECT SUNLIGHT
AND SPOT LIGHT ARTIFICIAL ILLUMINATION.
WARNING! TO AVOID AN ELECTRIC SHOCK, APPLY TO A QUALIFIED SPECIALIST TO
REPLACE THE LAMP.
IT IS PROHIBITED TO DISPOSE THE USED LAMPS IN THE DOMESTIC GARBAGE
CONTAINERS. AFTER A LAMP HAS BEEN REPLACED, IT SHALL BE HANDED IN TO THE
SERVICE OF FLUORESCENT LAMPS DISPOSAL.
MULTIFUNCTIONAL COUNTERFEIT DETECTOR DORS 1050MULTIFUNCTIONAL COUNTERFEIT DETECTOR DORS 1050
Multifunctional counterfeit detector DORS 1050........................................................................ 1 pc.
AC adapter................................................................................................................................. 1 pc.
User manual............................................................................................................................... 1 pc.
Packaging.................................................................................................................................. 1 set
DELIVERY SET
1
2 3
4
5
6
7
Rear viewFront view
Mark of
magnetizing area
А
А
Fig.1. APPEARANCE
B
8
1 Power switch;
2 TFT display;
3 LED:
Flashing green when
detecting magnetic marks;
4 Button for switching the
lighting mode:
UV or White light;
5 Magnetic sensor;
6 UV lamp;
7 White light source;
8 Jack for AC adapter.