Dors 1050 - Troubleshooting Common Issues; Technical Specifications and Support; Device Specifications

1312
MULTIFUNCTIONAL COUNTERFEIT DETECTOR DORS 1050MULTIFUNCTIONAL COUNTERFEIT DETECTOR DORS 1050
3. Remove the failed lamp 6 together with its protection covers 11 out of the holders 10 (see Fig. 2).
4. Remove (shift off) the lamp protection covers 11.
5. Take a new lamp from the package and inspect it: the glass bulb shall be devoid of scratches and
chipping, the lamp shall not be damaged, and the glass bulb surface shall not be contaminated.
6
9
6 – UV lamp
9 – Protective cover catch
10 – UV-lamp holder
11 – UV-lamp protective
cover
Fig. 2 Removing of the UV-lamp
Protective cover
10
11 11
Bottomside view
6. Insert the lamp into the holders up to the stop. Holding the lamp by two fingers of each hand, turn it
around its axis by a quarter of a turn.
Make sure the lamp is fixed in the holders.
7. Put on a protective cover 11 on each lamp holder (no tool is required).
8. Install the device in a working position and make a trial turning on UV light, make sure that the
failure is recovered.
9. Pack the failed lamp and hand it over to a specialized disposal service.
ATTENTION! DO NOT INSTALL IN THE DEVICE A LAMP HAVING MECHANICAL
DAMAGES AND BULB CONTAMINATION!
The device fails to switch on (display doesn’t light):
■ Check the device connection to the power supply. If the device isn’t connected to AC
adapter or to power sypply, connect it. If the device still fails to switch on, call your supplier.
The device switches on, but the white light has failed:
■ Call your supplier.
The device switches on, but the UV light has failed:
■ Replace the UV lamp of the recommended type.
TROUBLESHOOTING
SPECIFICATIONS
Supply voltage................................................................................................. 190 -240 V ~ 50/60 Hz
Current consumption....................................................................................... 0,08-0,06 А
Power consumption, not more than.................................................................. 14 W
Weight (not more than)..................................................................................... 0,48 kg
Overall dimensions (Width х Depth х Height): .................................................. 200x87x119 mm
Power of UV source......................................................................................... 1 х4 W
Peak wavelength of UV-radiation..................................................................... 365 nm
Operating range of IR source............................................................................ 800 -1000 nm
Operating temperature..................................................................................... +5 to +40°С