Replace MRS magnetic board
Replace big magnetic sensor
Replace magnetic board on the right
4. Detective error message display and solutions
If one of the following error messages is displayed on the LCD during the course of
counting/sorting, please handle them as per the following solutions after the machine is stopped.
1. Press "RESET" to continue the counting
2. If it is often displayed, adjust the adjusting screw toward the
clockwise direction to increase clearance.
Some banknotes are connected or overlapped
1. Put the banknotes on the banknote stacker back to the banknote
2. If it is often displayed, adjust adjusting screw toward the
counter-clockwise direction to decrease clearance.
Half piece or incomplete banknote.
1.Remove it and continue the counting
Counterfeit suspicious banknote
1.Remove it and continue counting
2.Clean away the dust on magnetic sensor
3.Replace magnetic sensor
The banknotes are nonconforming in size
1. Remove them and continue the counting.
2. Adjust counting IR sensor.
Denomination different
1.Remove suspect notes and re-count.
To Next Page
Loading...