Dover Markem-Imaje 5200 Instruction Manual

Safety - Installation
Instructionmanual
8
■ Installation requirements
Installation must be performed without fail by a Markem-Imaje
technicians team. Any person modifying the installation shall be
whollyliableforsuchmodication.
The printer must be installed in accordance with applicable
requirements.
TheModel5200canhaveuptotwoprintheads.
TheModel5400canhaveuptofourprintheads.
Determinealocationfortheprinterthat:
• Providesaccesstothefrontandrearoftheenclosure,
includingaminimumof15cm(6”)clearanceintherearfor
adequatecoolingventilation.
• Positionstheprinthead(s)within3m(10’)oftheenclosure.
• Providessturdy,leveloorspace.
• Meetsenvironmentalandelectricalspecications.
Ensuretheelectricalrequirementsaresatised:
• Theprintermustbeconnectedtoa50–60Hz,single-phase
ACpowersupplyelectricitynetwork,1450Wmaximum(Model
5200)or2530Wmaximum(Model5400),withearthground
usingthecablesuppliedwiththeprinter.
• Theenduserisresponsibleforsupplyinganappropriateplug
orwiringtoaterminalblockontheACpowercord.
• TheACvoltagecongurationmustbeveriedorchangedto
matchtheenduser’sACvoltageservice.
• Forelectricalcharacteristics,seetheSerial/I.D./RatingLabel
ontherearoftheenclosure,nearthepowerswitch.

Dover Markem-Imaje 5200 Specifications

General

Brand	Dover
Model	Markem-Imaje 5200
Category	Printer
Language	English