Section 5 Power ON/OFF
IMPORTANT: Only authorized/trained personnel can energize the console and must obey
the manufacturer's instructions. Operation must obey the safety instructions shown in the
Installation Manual (M2050-EU).
To energize the console:
1. Make sure that the power button is in the OFF position (0).
2. Connect the power cable.
3. Connect the corporate network cable, if necessary.
4. Push the power button to the ON position (1).
If the console is not configured when it is energized it will cause an alarm because it does not communicate
with a tank. Push the red arrows up or down until you see the page "ALARM LOG." Push the ACK button to
stop the alarm.
To make changes to the console configuration, refer to the MagLink LX Configuration Guide M2051-EU.
To de-energize the console, push the power button to the OFF position.
NOTE: The Maglink-LX console uses an industrial grade SD card. Safe data storage is
available if there is power loss.
M2052-EU Rev.: 1 Dover Fueling Solutions
Page 13
To Next Page
Loading...
