A16
E1 appears
Use the arrows to select the appropriate code (0010 for no event)
Press on the number of the menu to confirm (ex. # 1)
Step #2 Suggested values
SP2 appears.
Use the arrows to adjust to the desired temperature (400°F)
Press on the number of the menu to confirm (ex. # 1)
t2 appears
Use the arrows to select the desired timing (00:15)
Press on the number of the menu to confirm (ex. # 1)
E2 appears
Use the arrows to select the appropriate code (0010 for buzzer)
Press on the number of the menu to confirm (ex. # 1)
Step #3 Suggested values
SP3 appears.
Use the arrows to adjust to the desired temperature (400°F)
Press on the number of the menu to confirm (ex. # 1)
t3 appears
Use the arrows to select the desired timing (00:01)
Press on the number of the menu to confirm (ex. # 1)
E3 appears
Use the arrows to select the desired code (0000 for no event)
Press on the number of the menu to confirm (ex. # 1)
To get out of the programming mode, press #12 and then press "CLOCK" twice (#12, CLOCK,
CLOCK). The screen will show 00:00.
Note: You should always use menu #1 for preheating because the controls starts automatically with
this menu.
WARNING
Never use program #1 for a steam cycle because it will start automatically when the oven is
turned on.
To Next Page
Loading...
