A12
TROUBLESHOOTING
BEFORE CALLING FOR SERVICE
ANSWERS TO MOST FREQUENT QUESTIONS
Always cut off the main power before replacing any parts.
Control parts on the front control:
Remove the hood control panel of the oven by
screwing out the screws.
Gas and motor system on the back of oven:
Pull the oven and screw out of the back panels.
Questions Solutions
The oven does not turn on.
Check the breakers on the front panel.
Check the breakers of the building.
Check if the doors are tightly closed.
Check the motor fuses and the overload relays
located in the electrical control panel.
The oven does not produce heat.
• Make sure the thermostat is adjusted to a
temperature high enough to turn on the pilot
light.
1. If the oven blowers are not on, check the
overload relays located in the control
compartment. If anyone of these is
disengaged, call for a qualified technician.
E.. If the oven blowers are on:
• Check that the manual shut-off valve is open
correctly.
To start it over, simply put the thermostat to the
“OFF” position, wait at least 10 seconds, then
reset it at the desired temperature. The burner
will start up and you can see the flame through
the hole near the gas input. You can repeat this
operation three times. If it does not start up
again, contact our company or a certified gas
technician.
To Next Page
Loading...
Need help?
General
