Mach LED 150F / 150 / 150FP
59320002 Edition 12 08.08.2018 / Bak We page 17/26
7.2 Electrical data
Mach LED 150F Mach LED 150 Mach LED 150FP
Power consumption 35 W 35 W 35 W
Operating voltage DC 24 V DC 24 V DC 24 V DC
Current 1,45 A 1,45 A 1,45 A
7.3 Information regarding the electrical installation
When turned ON, the examination light MACH LED 150F / 150 / 150FP is exposed to a current peak.
The examination light MACH LED 150F / 150 /150FP is delivered with a Dr. Mach power supply.
It is an electronic power supply with a wide-range input, input voltage 100 – 240V AC, 50 – 60Hz, output
voltage 24V DC.
In case there is a switch-over relay needed for a emergency power supply on site, this switch over relay
must be ordered separately at Dr. Mach.
In case of a power supply provided by the customer, the following points must be observed:
• The OT-light works with 24V DC (direct voltage).
• The direct voltage provided by the hospital must have a maximum undulation of 5%.
Warning!
The light is class I. equipment. In order to avoid the risk of an electric shock, the equipment must
be connected to a mains supply with protective earth.
7.4
Weights
Light Weight
Mach LED 150F 3,5 kg*
Mach LED 150 3,5 kg*
Mach LED 150FP 3,5 kg*
* without handle
To Next Page
Loading...
