MAKING ICE
How to Get Started
Open the top cover, remove the ice bin. 1.
Plug in the ice maker and let it enter standby mode. The "ON/OFF" indicator will turn red.1.
Add ice machine cleaning water to the reservoir. Close the top cover lid. 2.
Tap the “CLEAN” button to activate the self-cleaning function. The “CLEAN” indicator lights on.3.
The self-cleaning function will run for 5 minutes.4.
If you want to manually shut down the self-cleaning function, tap the "CLEAN" button again. It is
recommended to allow the self-cleaning process to last at least 30 seconds.
5.
Fill reservoir with purified or distilled (safe to drink) water up to the MAX fill line.2.
On Ice Producing
While the ice maker is on, check the "Add Water" indicator periodically. If there is not enough water
in the reservoir to produce ice, the ice maker will stop automatically, and the “Add Water" indicator
will light up. Add water and not surpass the MAX fill line, tap the power button to enter standby
mode, and tap again to restart making ice.
1.
Cleaning and Maintenance
Drain Water
The ice maker has a built-in self-cleaning function and it is highly recommended that you use this
function to clean this appliance before first use.
Turn On The Self-cleaning Function
The ice maker automatically turns off when the ice bin is full, and the “Ice Full" indicator will light up.
And it will automatically continue to make ice after detecting that there is no obstruction at the ice
outlet for 30 seconds.
2.
Replace the water in the reservoir every 24 hours to ensure a reasonable level of hygiene. If the
appliance is not in use for a few days, drain all water from the reservoir and refill it before using
again.
3.
Place the ice bin back into the appliance and close the cover lid. 3.
Plug in the ice maker.4.
Tap the ON/OFF button once to turn the ice maker on. 5.
Purified or distilled water is strongly recommended for ice making to prevent scaling. If you
use tap or drinking water, it is recommended to use an ice machine cleaner and start
self-cleaning function regularly every week to prevent scale accumulation.
NOTE
NOTE
When the ice maker is powered on, it runs a two-cycle self-cleaning process that lasts about
2-3 minutes, which helps the machine make ice more smoothly.
Add cleaning water Tap “CLEAN” button Self-cleaning for 5 mins
Pull up to unhook
Pull up to unhook
Lay down the tube
Remove the plug, drain water
Unplug the appliance Clean with soft cloth
5 mins
- 09 - - 10 -
To Next Page
Loading...