CONTACT US AT www.DRpower.com 17
Checking Battery Charge
Check the charge percentage of your 62V Battery by pushing the Indicator
Button on the front of the Battery (Figure 20). The number of Green LED
indicators will tell you the % of power left in the battery. 1 LED = 25%, 2 LEDs =
50%, 3 LEDs = 75% and 4 LEDs = 100%.
If you press the Indicator Button and only the fourth LED flashes, the Battery
needs charging.
Charger indicator Lights (Figure 21)
Red LED Lit, green LED is not lit; The Charger is plugged in but the Battery is
not installed (no load condition).
Green LED blinks, red LED is not lit; Battery is charging normally.
The green LED is on, red LED is not lit; Battery is fully charged.
Green LED is not lit, red LED blinks; There is a fault with the Battery or Charger.
Remove the Battery from the Charger and wait about 30 minutes, then reinsert
the Battery into the Charger.
If the Battery does not hold its charge for very long under normal conditions or
it simply won’t hold a charge, then replace it. You can purchase a replacement
Battery directly from us at www.DRpower.com.
20
To Next Page
Loading...
Need help?
General
