CONTACT US AT www.DRpower.com 23
Attaching the Collector to the Cart
1. Turn the Enclosure over so it is right side up, with the open side on the floor.
2. Close the Cart onto the Frame until the Dump Lever holds it down. Confirm the handle is fully engaged and holds closed.
3. With the help of another person, place the Collector onto the Cart and align the Hinge Halves. With the Hinge Halves
aligned to the cart, push the Hinge in so they set in place (Figure 54).
4. Insert the Hinge Pin through the holes in the Hinges. The fit may be tight for this initial setup. Use a rubber hammer to tap
the Pin in if necessary.
5. Insert Hitch Clips in the holes at the ends of the Pin to secure it (Figure 55).
6. Pull the Enclosure Sleeve around the Outlet Chute (Figure 56).
7. Attach the Cable Link by removing it from the impeller housing (Figure 57), turning the hex portion of the link to open it up,
then attaching it to the Enclosure Eyebolt (Figure 56).
To Next Page
Loading...
