To Next Page

To Previous Page

Check the Tire Pressure

Tools Needed:

 Tire Pressure Gauge

 Air Compressor

1. Remove the Valve Stem Protective Cap (Figure 8) and check the tire

pressure with a Tire Pressure Gauge.

2. Compare the tire pressure reading from step 1 with the manufacturer's

recommended tire pressure stamped on the side of the tire.

3. If the pressure is too low, add air through the Valve Stem with an air hose.

4. Replace the Valve Stem Protective Cap when finished.

Connect the Battery

NOTE: The Battery may have been shipped with a protective Cap over the negative

Terminal and the Cap will need to be removed to connect the Negative

Wire.

1. Connect the Black Negative Terminal onto the negative Battery Lug (Figure

9).

Valve Stem

Protective Cap

Figure 8

Do not over inflate the tires. Inflate to the manufacturers recommended

pressure found on the tires.

Battery

Figure 9

Negative

Terminal

Questions and Answers:

Need help?

Do you have a question about the DR Stump Grinder and is the answer not in the manual?

DR Stump Grinder Specifications

General