Dräger caleo - Page 12

Important Safety Information
12
Operating Instructions Caleo, Software 2.n
CAUTION !
Always verify that monitor shelves and other accessories are
securely attached.
Always observe the following limits:
Maximum overall load must not exceed 66 kg (145.5 lbs)
(see page 170).
For items attached to column on swivel shelves, do not
exceed load of 3 kg (6.6 lbs).
When installing accessories, please note:
z Accessory equipment must not collide with the unit when
adjusting tilt angle and height of Caleo.
z Accessory equipment on the handle side does not move
with the main unit during height adjustment of Caleo
(Handle side, see page 170).
CAUTION !
Maximum loads for
– pole 38 mm/600 is 10 kg (22 lbs).
– pole 38 mm/310 is 10 kg (22 lbs).
– pole 25 mm/600 is 3 kg (6.6 lbs).
Max. distance between loads and pole: 150 mm (6 inches).
CAUTION !
When mounting control unit to its pole, ensure that there is
sufficient space to swivel the control unit (see "Tilting the
bed", page 48).
CAUTION !
Only qualified technical personnel may move the control unit
from the wall side to handle side or vice versa.
CAUTION !
Do not remove cable to the control unit from the cable guides
on the basic pole.
Make sure there is sufficient space to swivel and tilt the unit.
CAUTION !
Maximum load per hook is 3 kg (6.6 lbs).
CAUTION !
Maximum load for swivel tray is 3 kg (6.6 lbs).
Ensure sufficient space for swiveling!
CAUTION !
Maximum load for compact rail clamp is 5 kg (11 lbs).
CAUTION !
Do not install incubator controller on telescoping column.
CAUTION !
Maximum load for base pole is 10 kg (22 lbs).
Max. distance between loads and pole: 150 mm (6 inches).
CAUTION !
Maximum load for instrument tray is 2 kg (4.4 lbs).
CAUTION !
Maximum loads for pole extensions
– 38 mm/600 is 5 kg (11 lbs).
– 38 mm/310 is 5 kg (11 lbs).
– 25 mm/600 is 3 kg (6.6 lbs).
Max. distance between loads and pole: 150 mm (6 inches).
CAUTION !
Maximum load for notebook holder is 3 kg (6.6 lbs).
CAUTION !
Maximum load for monitor shelf is 20 kg (44 lbs).
Do not exceed the maximum installation height.
Vertical distance between monitor shelf and stand must not
exceed 20 cm (7.8 inches) on the wall side and 100 cm
(39 inches) on the handle side (see page 170).
CAUTION !
Always check that connecting O
2 supply hose is of sufficient
length when using independent O
2 flowmeter, allowing for the
height adjustments of the bassinet.
CAUTION !
The permissible O
2 inlet pressure is between 300 and
600 kPa (43.5 and 87 psi).
CAUTION !
Maximum load for drawer is 7 kg (15 lbs).
CAUTION !
Always take care not to damage sensor unit inside the
incubator when manipulating canopy !