Preparation
32
Operating Instructions Caleo, Software 2.n
Before Using Incubator For the First Time
Installing Accessories
Preparation
Before Using Incubator For the First Time
z Check that all packaging materials have been removed
completely.
z Check that line voltage matches that specification on rating
plate (see page 25).
z Check that the elevation above sea level has been entered
correctly for the location of the incubator (see page 106).
Installing Accessories
Accessory poles
Screw on
pole 38 mm/600 (2M 50 691), or, alternatively
pole 38 mm/310 (2M 50 688), or, alternatively
pole 25 mm/600 (2M 50 689).
z Remove cover plate from the frame base.
z Screw pole fully into the frame base and tighten firmly.
Check that it is securely held in position.
CAUTION !
Always verify that monitor shelves and other accessories are
securely attached.
Always observe the following limits:
Maximum overall load must not exceed 66 kg (145.5 lbs)
(see page 170).
For items attached to column on swivel shelves, do not
exceed load of 3 kg (6.6 lbs).
When installing accessories, please note:
z Accessory equipment must not collide with the unit when
adjusting tilt angle and height of Caleo.
z Accessory equipment on the handle side does not move
with the main unit during height adjustment of Caleo
(Handle side, see page 170).
CAUTION !
Maximum loads for
– pole 38 mm/600 is 10 kg (22 lbs).
– pole 38 mm/310 is 10 kg (22 lbs).
– pole 25 mm/600 is 3 kg (6.6 lbs).
Max. distance between loads and pole: 150 mm (6 inches).
To Next Page
Loading...
