Preparation
44
Operating Instructions Caleo, Software 2.n
Use of Doors, Ports, and Bed Adjusting Mechanism
To remove the canopy:
1 Grasp handles on the sides of the canopy with both hands.
2 Lift canopy horizontally off the supports.
Re-installing the canopy:
5 Place canopy horizontally, with the guide pins sliding into
the holes in the canopy supports.
Sliding out the bed
z Open front door and fold it down.
Pull the bed out:
3 Turn both knobs to the vertical position marked ,
4 Pull bed out towards the front as far as it will go, using the
recessed handle or the knobs.
z Upon completion of infant care procedures, push the bed
back in until it clicks into place. Turn knobs to the horizontal
position marked and close front door.
CAUTION !
Always take care not to damage sensor unit inside the
incubator when manipulating canopy !
WARNING !
Always observe the maximum load of the infant bed
(5 kg, 11 lbs).
WARNING !
Never leave infant unattended when the bed has been
pulled out to avoid any risk of an infant falling out of an
incubator.
WARNING !
Do not lean on the bed when it is pulled out. Equipment
damage with risk of patient injury may result.
WARNING !
Always ensure that the bed is pushed all the way in!
Otherwise the ducted flow of warm air will be interrupted,
and the infant may be warmed or cooled excessively.
To Next Page
Loading...
