Dräger EVITA XL

For full manual see http://warney/ServiceManuals/D-H/DRAGER/
Ventilating Infants and Small Children
• Patient mode »Pediatrics«
Using infant size patient circuit connectors 6-42kg
1 Clamp hinged circuit support arm to rail on the left-hand
side and tighten screws.
• Connect ventilator circuit segments of appropriate lengths
(lengths suggested are in meters).
2 Install water trap(s) in vertical position.
Patient mode: »Adults« 42kg plus
1 Attach circuit support arm to the rail on the left-hand side of
the ventilator and tighten screws.
• Connect ventilator circuit segments of appropriate lengths
(lengths suggested are in meters).
2 Install water trap(s) in vertical position if using circuit with them
3 Connect Y-piece, with the rubber sleeve of the Y-piece on
the inspiratory side (reusable silicone circuit).
Operatin
g
Concept
Control Panel
Its main elements are:
1 A large screen with all the information and controls needed for ventilation.
2 Fixed function keys ("hard" keys) major on-screen functions,
Alarm Silence« for silencing the
audible alarm for two minutes.
Alarm Limits« for adjusting
alarm limits.
Ventilator Settings« for setting ventilation mode and parameters.
Unassigned key for future functions.
» Sensor Parameter« for calibrating sensors.activating/deactivating monitoring
. » System Setup« for configuringbsystem functions.
Start/Standby« for selecting standby mode or normal operation.
3 Central rotary dial knob for selecting, confirming settings on-screen.
The Screen...
.
1 Alarm messages
2 Operator prompts
• Therapy status with ventilation mode,e.g. SIMV,
• Patient mode, e.g. " Adult" for adults.
4 Waveforms, loops, and trends visualizing ventilation,
5 Presentation of set ventilation parameters
6 Essential, measured values of ventilation
7 Humidification type and status.
8 Touch-sensitive screen keys for the specific screen pages
9 Power supply indicator.
To select a screen page:
• Touch the respective screen key:
• Main« to select the main screen.
• Values« to select a different group of measured
values in the field for numerical values.
• »Data...« to display all measured values,
the logbook or trends on an additional screen
»Special Procedure... nebulization, O2 for suction
QUICK USER GUIDE FOR EVITA XL

Dräger EVITA XL Specifications

General

Type	Ventilator
Manufacturer	Dräger
Model	EVITA XL
Connectivity	RS-232, Ethernet
Modes of Ventilation	Volume Control, Pressure Control, SIMV, CPAP
Tidal Volume Range	20 to 2000 ml
Respiratory Rate	2 to 100 breaths/min
FiO2 Range	21% to 100%
Display	Color touchscreen
Power Supply	100 to 240 V, 50/60 Hz
Patient Range	Neonatal to Adult
Monitoring	Pressure, Volume, Flow, SpO2
Alarms	Apnea, High Pressure, Low Pressure

Summary

Operating Concept

Control Panel

Overview of the control panel elements, including screen, fixed function keys, and rotary dial.

The Screen

Details on screen elements like alarm messages, operator prompts, therapy status, and navigation.

Device Check and Leak Test

Checks of Readiness for Operation

Procedures to confirm the ventilator is working properly and ready for operation before use.

System Tests

Tests related to expiratory valve, flow sensor, humidifier, patient hoses, and temperature sensor.

Function Tests

Tests for Air-O2 switch valve, safety relief valve, gas supply pressure, and back-up alarm.

Sensor Tests

Calibration and zeroing procedures for flow, O2, and CO2 sensors, including patient circuit leak test.

Leak Test

Procedure for performing and interpreting the leak test for patient circuit integrity.