Dräger Polaris 600

Supplement to the instructions for use Polaris 600 17
English
Height adjustment
The handle (A) can be used to adjust the height of the tubular
stand by approx. 400 mm. There is a snap lock for the handle at
the top part (operating position) and another one at the bottom
part (transport position).
1 Grip the handle at the gripping surface and pull it sideways (A).
2 Set the light to the operating position (B).
3 Let the handle snap back into place (C).
059
CAUTION
Risk of pinching
Fingers can be trapped at the transition between the tubular
stand and spring arm.
– Do not grip the top part of the tubular stand to move the light.
– Only move the light using the handle of the tubular stand.
– Do not grip the upper part of the tubular stand when
adjusting the height of the light.
– Always use the handle when adjusting the height of the light.
CAUTION
Risk of pinching
Fingers can be trapped at the transition between the tubular
stand and spring arm.
B
A
C