Need help?Do you have a question about the Dräger Vamos and is the answer not in the manual?
Outlines user's duty for correct and safe operation.
Defines Dräger's liability limitations regarding product use and warranty.
Explains key terms used in the manual.
Describes formatting for display messages and controls.
Lists critical safety warnings for overall product use.
Safety measures before starting device operation.
Safety measures during active monitoring.
Safety measures for cleaning and maintenance.
Details the function of the main dial knob for navigation and selection.
Explains the layout and components of the monitor's screen.
Describes how to silence alarms and interpret indicator lights.
Instructions on how to place the monitor safely.
Steps for connecting the monitor to AC power.
Guide for inserting the WaterLock water trap.
Procedure for attaching the gas sample line.
How to connect the hose for waste gas removal.
Steps for attaching the SpO2 sensor.
Detailed steps to power on the monitor and enter measurement mode.
How to select the correct anesthetic agent for accurate measurement.
Explains how to interpret SpO2 and pulse rate displays.
Guidance to ensure accurate SpO2 readings by preventing interference.
Procedures for attaching Durasensor and Oxisensor models.
Guidance on reusing sensors and alternative application sites.
How to configure lower and upper alarm limits for various parameters.
How to set the units and scale for CO2 measurements.
How to choose averaging intervals for SpO2 readings.
Adjusting the volume for pulse and alarm tones.
Adjusting screen brightness and communication baud rate.
Enabling or disabling specific measurement parameters.
Steps to disconnect and disassemble the device.
How to manage the water trap during care and disposal.
Procedures for cleaning and disinfecting the monitor.
Schedule for required inspections and servicing.
Guidelines for disposing of the monitor and its components.
Identifies and explains components on the front of the device.
Identifies and explains components on the rear of the device.
Specifies operating and storage temperature, pressure, humidity.
Details CO2 measurement accuracy, range, and response times.
Details anesthetic gas measurement accuracy, range, and response times.
Details SpO2 and pulse rate accuracy, range, and averaging.
Describes RS232 and MEDIBUS connection details and settings.
Covers enclosure protection, EMC, and EC classification.
Explains how the device measures gas concentrations using light absorption.
Explains the principle of SpO2 measurement using light absorption.
Factors affecting measurement accuracy like respiratory rate.
To Next Page
General
