Operation in Measurement Mode
32
Operating Instructions Vamos, 1. US ed.
Terminating Operation
Terminating Operation
● Remove the SpO2 sensor from the patient.
To keep the monitor ready for further use:
● Press Standby key » « to switch monitor to Standby
mode. The yellow LED in the key lights up.
The next time the monitor is operated, the following individually
set will again be activated:
—CO
2 unit
— display brightness
— MEDIBUS baud rate
— language
For all other parameters the default values will be activated.
To shut down the monitor:
● Switch the ON/OFF switch in the back of the unit to »%«
in order toswitch off the monitor.
02737163
D
Vamos
02837163
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
To Next Page
Loading...
