Dräger Vamos - Display Brightness and Baud Rate

Operation in Measurement Mode
28
Operating Instructions Vamos, 1. US ed.
Configure Display Brightness and MEDIBUS Baud Rate
Configure Display Brightness and MEDIBUS
Baud Rate
The brightness of the display can be adjusted in two steps:
high, low
The following baud rates of the MEDIBUS RS 232 interface
can be selected:
1200, 9600, 19200
To set:
● Turn or press dial knob to select main menu.
● Turn dial knob to select »Config.« parameter.
● Press dial knob to open the configuration menu
● Turn dial knob to set display brightness
● Press dial knob to confirm the setting.
The selected brightness is marked with an arrow.
● Turn dial knob to set baud rate.
● Press dial knob to confirm the setting.
The selected baud rate is marked with an arrow.
● Press dial knob again to return to the measurement
display.
The settings for brightness and baud rate will be used until
they are changed by the user again.
highBrightn.
low
Fi
Fet
Hal
[%]
N2O
[%]
CO2
[%]
[1/min]
[%]
1200
SpO2
Pulse
98
110
Config.
0.6
0.1
30
25
0.0
4.5
9600
MEDIBUS
(Baud)
19200
exit
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS