Dräger X-dock User Manual

Dräger X-dock
Frequently Asked Questions
SOFTWARE What do I have to consider when installing the PC Software?
With the simplest installation variant there is not much to consider: You only have
to enter the IP of the computer/server you use and assign an IP to the system.
It is important to ensure that no firewall blocks the data communication.
For further information please contact your Dräger representative.
In the extended version you can also change the ports used and you may also
use your existing database later, if applicable.
One possibility is to use an USB stick. When logged in, all available certificates
and datalogger can be copied onto the stick via the menu.
How can I access the data of the station, if I do not use an X-dock Manager?
HOME
 
Yes. As of now apart from Ecal Draegerware as well supports the X-dock. To do
so, the server part of the X-dock software must be installed and the Draegerware
configured accordingly. As soon as this was done Draegerware automatically
receives the test results of the gas detection instruments and the evaluations
can be done via the Draegerware as usual.
Does Draegerware also support X-dock?
This test method is used to configure an automatically executed test process, for
example, running a test every day at 7:30 in the morning. This means supported
devices are charged at night for an early morning automated start and test.
Which function does the scheduler offer?
9094227_X-dock_FAQs_210x297_ENGL_5 20.11.13 12:10 Seite 5

Dräger X-dock Specifications

General

Power Supply	100 – 240 VAC, 50 – 60 Hz
Humidity	10 to 95 % RH, non-condensing
Data Storage	Internal memory for device data, calibration data, and test results
Interface	USB, Ethernet
Device Type	Automated test and calibration station
Calibration	Automatic calibration
Bump Test	Automatic bump test
Supported Gases	Depends on the gas detector being tested (e.g., H2S, CO, O2, LEL)
Compatibility	Compatible with Dräger portable gas detectors