Dräger X-dock User Manual

Dräger X-dock
Frequently Asked Questions
HOME
 
Yes. The X-dock Manager offers this option. However, under the settings of the
X-dock you have to configure a SMTP server so that the e-mail can be sent via
this server.
SOFTWARE Can I send the reports via e-mail as well?
There are two ways to do this.
1) In the Device tab you can change the sort order. In this case all you need to
do is to sort by “Next Bump Test Date” or “Next Calibration Date”. Overdue
devices will then appear at the top of the list.
2) In the Professional Version there are reports in the Report tab entitled
“Overdue Gassing Tests” and “Overdue Adjustments” respectively. The
corresponding report can then be created periodically, but also as a one-off.
This will show all overdue devices.
I can see in the Cockpit that tests and adjustments are overdue. How can I find out which
devices are affected?
9094227_X-dock_FAQs_210x297_ENGL_5 20.11.13 12:10 Seite 7

Dräger X-dock Specifications

General

Power Supply	100 – 240 VAC, 50 – 60 Hz
Humidity	10 to 95 % RH, non-condensing
Data Storage	Internal memory for device data, calibration data, and test results
Interface	USB, Ethernet
Device Type	Automated test and calibration station
Calibration	Automatic calibration
Bump Test	Automatic bump test
Supported Gases	Depends on the gas detector being tested (e.g., H2S, CO, O2, LEL)
Compatibility	Compatible with Dräger portable gas detectors