• Use a dry cloth ONLY to clean the housing of this device.
CAUTION! DO NOT use abrasives, solvents
or other aggressive chemicals as these may
damage plastic or insulated parts.
• Replace the probes IMMEDIATELY if they are damaged
in any way or the conductors are exposed; contact
Draper Tools for replacement options.
• Important: Replacement probes must be rated CAT III
1,000V.
• If the low battery indicator is shown on the display
screen, replace the battery as soon as possible; see 6.1
Installing the Battery.
• If the fuse must be replaced, access the device circuit
board (see 6.1), remove the fuse from its holder and
install an equivalent fuse its place.
• Important: This product requires a F200mA/250V fuse.
• Remove the battery when storing the device for
extended periods.
• Store the device in a cool, clean and dry environment,
out of direct sunlight and out of reach of children.
7.2 Disposal
For spare parts, servicing, and repair and replacement
options, please contact the Draper Tools Product Helpline
for details of your nearest authorised agent.
Draper Tools will endeavour to hold any spare parts, if
applicable, for seven years from the date that it sells the
nal matching stock item.
Any servicing or repairs carried out by unauthorised
personnel or installation of spare parts not supplied by
Draper Tools will invalidate your warranty.
At the end of its working life, dispose of the product
responsibly and in line with local regulations. Recycle
where possible.
• DO NOT dispose of this product with domestic waste;
most local authorities provide appropriate recycling
facilities.
• DO NOT burn or mutilate batteries; this may release
toxic or corrosive substances.
• Dispose of batteries separately and in accordance with
local regulations.
8. Warranty
Draper Tools products are carefully tested and inspected
before shipment and are guaranteed to be free from
defective materials and workmanship.
Should the tool develop a fault, return the complete tool to
your nearest distributor or contact Draper Tools directly.
Contact information can be found at the back of this
manual.
Proof of purchase must be provided.
If, upon inspection, it is found that the fault occurring is
due to defective materials or workmanship, repairs will be
carried out free of charge. This warranty period covers
parts and labour for 12 months from the date of purchase.
Where tools have been hired out, the warranty period
covers 90 days from the date of purchase.
This warranty does not apply to any consumable parts,
batteries or normal wear and tear, nor does it cover any
damage caused by misuse, careless or unsafe handling,
alterations, accidents, or repairs attempted or made by any
personnel other than the authorised Draper Tools repair
agent.
In all cases, to make a claim for faulty workmanship or
materials within the standard warranty period, please
contact or return the product to the place of purchase.
Proof of purchase may be required.
If the place of purchase is no longer trading or if you
experience any diculties with your warranty, please
contact Customer Services with the product details and
your proof of purchase. Contact details can be found at the
back of this manual.
If the tool is not covered by the terms of this warranty,
repairs and carriage charges will be quoted and charged
accordingly.
This warranty supersedes any other guarantees expressed
or implied and variations of its terms are not authorised.
Your Draper Tools guarantee is not eective until you can
produce, upon request, a dated receipt or invoice to verify
your purchase within the guarantee period.
Please note that this warranty is an additional benet and
does not aect your statutory rights.
Draper Tools Limited
– 7 –
To Next Page
Loading...
