Draytek Vigor2865 Series User Manual

26
4
4
.
.
4
4
L
L
T
T
E
E
M
M
o
o
d
d
e
e
m
m
S
S
e
e
t
t
u
u
p
p
(
(
L
L
T
T
E
E
m
m
o
o
d
d
e
e
l
l
s
s
o
o
n
n
l
l
y
y
)
)
The LTE modem integrated into DrayTek LTE routers (“L” suffix) can connect
directly to a mobile broadband network and operate as either a main internet
connection or a backup internet connection. The modem is integrated into the
router instead of using a separate USB modem and requires a SIM card to connect to
the mobile broadband network required.
The settings for the mobile broadband network will vary by provider, some will
require the APN (Access Point Name) while others may require that and a username
and password. If those details are not set, the mobile network may reject the
connection attempts of the Vigor LTE router, which will result in the router showing
no signal / no IP address.
To configure the LTE WAN interface on the router, it is first necessary to fit the SIM
card in the router, refer to section 3.2 for details of SIM card and antenna
installation.
After the SIM card has been installed, power on the router, access the router's web
interface and go to [WAN] > [General Setup] to confirm the LTE WAN options, by
clicking the LTE link:
In the LTE General Setup options, ensure that the connection is Enabled and set the
Active Mode as required.
If the internet connection should always be available, set it to Always On:

Draytek Vigor2865 Series Specifications

General

Brand	Draytek
Model	Vigor2865 Series
Category	Firewall
Language	English